Home › Code lookup › P0022
Powertrain code · Engine

P0022 "A" Camshaft Position - Timing Over-Retarded (Bank 2)

How urgent? Get it checked in the next few days

What it means

The "A" (usually intake) camshaft on bank 2 is further behind the position the computer asked for. The variable valve timing system is not controlling it correctly.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and change it if dirty or overdue, using the correct grade
  2. Remove and inspect the oil control valve for sludge or a stuck spool
  3. Check cam timing values with a scan tool before replacing the phaser or chain

Signs you may notice

  • Check engine light on
  • Rough idle, especially when warm
  • Hesitation or loss of power
  • Possible stalling or rattle at startup

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow, dirty or wrong-grade engine oil
  • CommonSticking or failed camshaft oil control valve
  • CommonWorn camshaft phaser or phaser stuck retarded
  • PossibleStretched timing chain or jumped timing
  • PossibleClogged oil screen at the oil control valve

Typical repair once the cause is confirmed

Start with an oil change. If it comes back, the oil control valve is the most common fix, then the phaser or timing chain.

Repair costInsufficient verified pricing for this vehicle and repair
Replace camshaft oil control valve (VVT solenoid). Prepare an itemized shop request.

Where it shows up

  • Often paired with P0012 on the Ford 5.4L 3-valve V8 when the cam phasers wear

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P0022 mean?

The "A" (usually intake) camshaft on bank 2 is further behind the position the computer asked for. The variable valve timing system is not controlling it correctly.

Can I drive with code P0022?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0022?

Common possibilities to test include: low, dirty or wrong-grade engine oil; sticking or failed camshaft oil control valve; worn camshaft phaser or phaser stuck retarded; stretched timing chain or jumped timing. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.