P0023 "B" Camshaft Position Actuator Circuit (Bank 2)
What it means
The engine uses an electric oil control valve to adjust the "B" (usually exhaust) camshaft timing on bank 2. The computer found a problem in the wiring or the valve itself, such as an open or shorted circuit.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the solenoid connector for oil, corrosion or a loose fit
- Measure the solenoid resistance and compare to spec
- Command the solenoid on with a scan tool and watch for a response
Signs you may notice
- Check engine light on
- Rough idle or stalling
- Reduced power and fuel economy
- Engine may run fine but with a light on
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed camshaft oil control valve (VVT solenoid)
- CommonDamaged wiring or loose connector at the solenoid
- PossibleOil leaking into the solenoid connector
- PossibleEngine computer driver fault
Typical repair once the cause is confirmed
Usually a new camshaft oil control valve, or a wiring or connector repair.
Common questions
What does P0023 mean?
The engine uses an electric oil control valve to adjust the "B" (usually exhaust) camshaft timing on bank 2. The computer found a problem in the wiring or the valve itself, such as an open or shorted circuit.
Can I drive with code P0023?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0023?
Common possibilities to test include: failed camshaft oil control valve (vvt solenoid); damaged wiring or loose connector at the solenoid; oil leaking into the solenoid connector; engine computer driver fault. A shop should confirm the cause before replacing parts.