P0025 "B" Camshaft Position - Timing Over-Retarded (Bank 2)
What it means
The "B" (usually exhaust) camshaft on bank 2 is further behind the position the computer asked for. The variable valve timing system is not controlling it correctly.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the oil level and change it if dirty or overdue, using the correct grade
- Remove and inspect the oil control valve for sludge or a stuck spool
- Check cam timing values with a scan tool before replacing the phaser or chain
Signs you may notice
- Check engine light on
- Rough idle, especially when warm
- Hesitation or loss of power
- Possible stalling or rattle at startup
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonLow, dirty or wrong-grade engine oil
- CommonSticking or failed camshaft oil control valve
- CommonWorn camshaft phaser or phaser stuck retarded
- PossibleStretched timing chain or jumped timing
- PossibleClogged oil screen at the oil control valve
Typical repair once the cause is confirmed
Start with an oil change. If it comes back, the oil control valve is the most common fix, then the phaser or timing chain.
Known on these vehicles
Common questions
What does P0025 mean?
The "B" (usually exhaust) camshaft on bank 2 is further behind the position the computer asked for. The variable valve timing system is not controlling it correctly.
Can I drive with code P0025?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0025?
Common possibilities to test include: low, dirty or wrong-grade engine oil; sticking or failed camshaft oil control valve; worn camshaft phaser or phaser stuck retarded; stretched timing chain or jumped timing. A shop should confirm the cause before replacing parts.