Home › Code lookup › P0028
Powertrain code · Engine

P0028 Intake Valve Control Solenoid Circuit Range/Performance (Bank 2)

How urgent? Get it checked in the next few days

What it means

The intake valve control solenoid on bank 2 helps change valve timing or lift. The computer sees that the solenoid circuit is working, but the result is not what it expected.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and condition
  2. Inspect the solenoid and its screen for sludge
  3. Check the solenoid wiring and resistance

Signs you may notice

  • Check engine light on
  • Rough idle or hesitation
  • Reduced power or fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSticking valve control solenoid
  • CommonLow, dirty or wrong-grade engine oil
  • PossibleWiring or connector problem at the solenoid
  • PossibleWorn camshaft phaser or timing components

Typical repair once the cause is confirmed

Often an oil change, then a new valve control solenoid if the code returns.

Repair costInsufficient verified pricing for this vehicle and repair
Replace valve control solenoid. Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0028 mean?

The intake valve control solenoid on bank 2 helps change valve timing or lift. The computer sees that the solenoid circuit is working, but the result is not what it expected.

Can I drive with code P0028?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0028?

Common possibilities to test include: sticking valve control solenoid; low, dirty or wrong-grade engine oil; wiring or connector problem at the solenoid; worn camshaft phaser or timing components. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.