Home › Code lookup › P002B
Powertrain code · Engine

P002B "B" Camshaft Profile Control Circuit Low (Bank 1)

How urgent? Book a check when convenient

What it means

Some engines can switch between two camshaft lobe shapes, one for economy and one for power. The computer found a voltage lower than expected in the control circuit for the "B" camshaft switching on bank 1.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and condition
  2. Inspect the solenoid connector and wiring
  3. Test the solenoid resistance and command it with a scan tool

Signs you may notice

  • Check engine light on
  • Less power at higher engine speeds
  • Engine may stay in one cam mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged wiring or loose connector to the cam profile solenoid
  • CommonFailed cam profile switching solenoid
  • PossibleLow or dirty engine oil affecting the switching mechanism
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a wiring repair or a new cam profile switching solenoid.

Walk through it step by step: Check engine light on →

Common questions

What does P002B mean?

Some engines can switch between two camshaft lobe shapes, one for economy and one for power. The computer found a voltage lower than expected in the control circuit for the "B" camshaft switching on bank 1.

Can I drive with code P002B?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P002B?

Common possibilities to test include: damaged wiring or loose connector to the cam profile solenoid; failed cam profile switching solenoid; low or dirty engine oil affecting the switching mechanism; engine computer driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.