Home › Code lookup › P0033
Powertrain code · Fuel and air

P0033 Turbocharger/Supercharger Bypass Valve Control Circuit

How urgent? Get it checked in the next few days

What it means

On turbocharged or supercharged engines, a bypass (blow-off or diverter) valve releases boost pressure when you lift off the gas. The computer found a fault, such as an open circuit, in the circuit that controls this valve.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the valve connector and wiring
  2. Check vacuum hoses around the turbo for cracks
  3. Command the valve with a scan tool and listen or watch for it to move

Signs you may notice

  • Check engine light on
  • Loss of power or slow boost build-up
  • Possible limp mode or whooshing noise

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed bypass (diverter) valve solenoid
  • CommonDamaged wiring or loose connector
  • PossibleCracked vacuum hose to the valve, on vacuum-operated types
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a new bypass valve or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace turbo bypass (diverter) valve. Prepare an itemized shop request.
Walk through it step by step: Car has no power when accelerating →

Common questions

What does P0033 mean?

On turbocharged or supercharged engines, a bypass (blow-off or diverter) valve releases boost pressure when you lift off the gas. The computer found a fault, such as an open circuit, in the circuit that controls this valve.

Can I drive with code P0033?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0033?

Common possibilities to test include: failed bypass (diverter) valve solenoid; damaged wiring or loose connector; cracked vacuum hose to the valve, on vacuum-operated types; engine computer driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.