Home › Code lookup › P0039
Powertrain code · Fuel and air

P0039 Turbocharger/Supercharger Bypass Valve Control Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The bypass (blow-off or diverter) valve on a boosted engine is not responding the way the computer expects, even though the circuit is not fully open or shorted.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the bypass valve and hoses for leaks or tears
  2. Check the wiring and connector
  3. Watch commanded vs actual boost on a scan tool

Signs you may notice

  • Check engine light on
  • Loss of power or uneven boost
  • Possible limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSticking or worn bypass valve
  • CommonTorn diaphragm in the bypass valve
  • PossibleBoost or vacuum leak near the valve
  • PossibleIntermittent wiring fault

Typical repair once the cause is confirmed

Usually a new bypass valve, or repair of a leaking boost hose.

Repair costInsufficient verified pricing for this vehicle and repair
Replace turbo bypass (diverter) valve. Prepare an itemized shop request.
Walk through it step by step: Car has no power when accelerating →

Common questions

What does P0039 mean?

The bypass (blow-off or diverter) valve on a boosted engine is not responding the way the computer expects, even though the circuit is not fully open or shorted.

Can I drive with code P0039?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0039?

Common possibilities to test include: sticking or worn bypass valve; torn diaphragm in the bypass valve; boost or vacuum leak near the valve; intermittent wiring fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.