Home › Code lookup › P003A
Powertrain code · Fuel and air

P003A Turbocharger/Supercharger Boost Control "A" Position Exceeded Learning Limit

How urgent? Get it checked in the next few days

What it means

The computer learns the normal resting and travel positions of the boost control actuator (often the wastegate or variable vane control). The "A" actuator position has drifted beyond what the computer will accept.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check whether the turbo or actuator was recently replaced and needs a relearn
  2. Inspect the actuator linkage for binding
  3. Run the actuator test or relearn with a scan tool

Signs you may notice

  • Check engine light on
  • Too little or too much boost
  • Possible limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn or sticking wastegate or vane mechanism
  • CommonFaulty boost control actuator or its position sensor
  • PossibleActuator not set up or relearned after a repair
  • PossibleCarbon buildup in the turbo

Typical repair once the cause is confirmed

Often an actuator relearn or a new boost actuator; a sticking turbo may need cleaning or replacement.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P003A mean?

The computer learns the normal resting and travel positions of the boost control actuator (often the wastegate or variable vane control). The "A" actuator position has drifted beyond what the computer will accept.

Can I drive with code P003A?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P003A?

Common possibilities to test include: worn or sticking wastegate or vane mechanism; faulty boost control actuator or its position sensor; actuator not set up or relearned after a repair; carbon buildup in the turbo. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.