Home › Code lookup › P003C
Powertrain code · Engine

P003C "A" Camshaft Profile Control Performance/Stuck Off (Bank 1)

How urgent? Book a check when convenient

What it means

Some engines can switch between two camshaft lobe shapes. On bank 1, the computer found the "A" cam switching system not switching properly or stuck in its off position.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and condition
  2. Check oil pressure
  3. Inspect the switching solenoid and its screen for sludge

Signs you may notice

  • Check engine light on
  • Less power at higher engine speeds
  • Possible lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow, dirty or wrong-grade engine oil
  • CommonSticking cam profile switching solenoid
  • PossibleLow oil pressure to the switching mechanism
  • PossibleWorn or sticking cam follower or locking pin

Typical repair once the cause is confirmed

Often an oil change and a new switching solenoid. Mechanical wear inside the valvetrain is less common.

Walk through it step by step: Check engine light on →

Common questions

What does P003C mean?

Some engines can switch between two camshaft lobe shapes. On bank 1, the computer found the "A" cam switching system not switching properly or stuck in its off position.

Can I drive with code P003C?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P003C?

Common possibilities to test include: low, dirty or wrong-grade engine oil; sticking cam profile switching solenoid; low oil pressure to the switching mechanism; worn or sticking cam follower or locking pin. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.