Home › Code lookup › P0040
Powertrain code · Emissions

P0040 Oxygen Sensor Signals Swapped (Bank 1 Sensor 1 / Bank 2 Sensor 1)

How urgent? Book a check when convenient

What it means

On a V-type engine there is an upstream oxygen sensor for each side. The computer has noticed that the bank 1 and bank 2 upstream sensor signals appear to be swapped.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check if oxygen sensors or exhaust parts were recently replaced
  2. Trace each sensor wire to make sure it plugs into the correct connector
  3. Watch both sensor readings while making one bank richer with a scan tool

Signs you may notice

  • Check engine light on
  • Possible rough running or poor fuel economy
  • May fail an emissions test

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSensor connectors plugged into the wrong side after a repair
  • CommonSensor harnesses routed or wired incorrectly
  • PossibleWrong sensors installed on each bank

Typical repair once the cause is confirmed

Usually correcting the connections or wiring so each sensor plugs into its own side.

Walk through it step by step: Check engine light on →

Common questions

What does P0040 mean?

On a V-type engine there is an upstream oxygen sensor for each side. The computer has noticed that the bank 1 and bank 2 upstream sensor signals appear to be swapped.

Can I drive with code P0040?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0040?

Common possibilities to test include: sensor connectors plugged into the wrong side after a repair; sensor harnesses routed or wired incorrectly; wrong sensors installed on each bank. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.