P0044 HO2S Heater Control Circuit High (Bank 1 Sensor 3)
What it means
Oxygen sensors have a built-in heater so they start working soon after a cold start. The computer found a voltage that is too high in the heater circuit of the third, furthest-downstream oxygen sensor on bank 1.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the oxygen sensor heater fuse
- Inspect the sensor wiring for melted or rubbed-through spots near the exhaust
- Measure the heater resistance at the sensor and compare to spec
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed heater inside the oxygen sensor
- CommonBlown fuse for the oxygen sensor heaters
- CommonDamaged or melted wiring near the exhaust
- PossibleCorroded or loose sensor connector
- PossibleEngine computer heater driver fault
Typical repair once the cause is confirmed
Most often a new oxygen sensor. If the fuse is blown, find the short that blew it before replacing the sensor.
Common questions
What does P0044 mean?
Oxygen sensors have a built-in heater so they start working soon after a cold start. The computer found a voltage that is too high in the heater circuit of the third, furthest-downstream oxygen sensor on bank 1.
Can I drive with code P0044?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0044?
Common possibilities to test include: failed heater inside the oxygen sensor; blown fuse for the oxygen sensor heaters; damaged or melted wiring near the exhaust; corroded or loose sensor connector. A shop should confirm the cause before replacing parts.