Home › Code lookup › P0046
Powertrain code · Fuel and air

P0046 Turbocharger/Supercharger Boost Control "A" Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The boost control system (usually a wastegate or variable vane actuator) sets how much pressure the turbo or supercharger makes. The computer found a response that does not match what it commanded in the "A" boost control circuit.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect vacuum and boost hoses for cracks or loose clamps
  2. Check the wastegate or vane linkage for binding
  3. Compare commanded and actual boost with a scan tool

Signs you may notice

  • Check engine light on
  • Loss of power or slow acceleration
  • Engine may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSticking wastegate or variable vane mechanism
  • CommonFaulty boost control solenoid or actuator
  • CommonCracked or leaking vacuum or boost hose
  • PossibleWiring or connector problem

Typical repair once the cause is confirmed

Often a sticking wastegate or vane linkage, a leaking hose, or a failed boost control solenoid.

Repair costInsufficient verified pricing for this vehicle and repair
Replace boost control solenoid. Prepare an itemized shop request.
Walk through it step by step: Car has no power when accelerating →

Common questions

What does P0046 mean?

The boost control system (usually a wastegate or variable vane actuator) sets how much pressure the turbo or supercharger makes. The computer found a response that does not match what it commanded in the "A" boost control circuit.

Can I drive with code P0046?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0046?

Common possibilities to test include: sticking wastegate or variable vane mechanism; faulty boost control solenoid or actuator; cracked or leaking vacuum or boost hose; wiring or connector problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.