P004B Turbocharger/Supercharger Boost Control "B" Circuit Range/Performance
What it means
The boost control system (usually a wastegate or variable vane actuator) sets how much pressure the turbo or supercharger makes. The computer found a response that does not match what it commanded in the "B" boost control circuit.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect vacuum and boost hoses for cracks or loose clamps
- Check the wastegate or vane linkage for binding
- Compare commanded and actual boost with a scan tool
Signs you may notice
- Check engine light on
- Loss of power or slow acceleration
- Engine may go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSticking wastegate or variable vane mechanism
- CommonFaulty boost control solenoid or actuator
- CommonCracked or leaking vacuum or boost hose
- PossibleWiring or connector problem
Typical repair once the cause is confirmed
Often a sticking wastegate or vane linkage, a leaking hose, or a failed boost control solenoid.
Common questions
What does P004B mean?
The boost control system (usually a wastegate or variable vane actuator) sets how much pressure the turbo or supercharger makes. The computer found a response that does not match what it commanded in the "B" boost control circuit.
Can I drive with code P004B?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P004B?
Common possibilities to test include: sticking wastegate or variable vane mechanism; faulty boost control solenoid or actuator; cracked or leaking vacuum or boost hose; wiring or connector problem. A shop should confirm the cause before replacing parts.