P004C Turbocharger/Supercharger Boost Control "B" Circuit Low
What it means
The boost control system (usually a wastegate or variable vane actuator) sets how much pressure the turbo or supercharger makes. The computer found a voltage that is too low in the "B" boost control circuit.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the boost control solenoid or actuator connector and wiring
- Measure the solenoid resistance and compare to spec
- Command the actuator with a scan tool and watch it move
Signs you may notice
- Check engine light on
- Loss of power or slow acceleration
- Engine may go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonDamaged wiring or loose connector to the boost control solenoid or actuator
- CommonFailed boost control solenoid or electronic actuator
- PossibleBlown fuse or poor power feed
- PossibleEngine computer driver fault
Typical repair once the cause is confirmed
Usually a wiring repair or a new boost control solenoid or actuator.
Common questions
What does P004C mean?
The boost control system (usually a wastegate or variable vane actuator) sets how much pressure the turbo or supercharger makes. The computer found a voltage that is too low in the "B" boost control circuit.
Can I drive with code P004C?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P004C?
Common possibilities to test include: damaged wiring or loose connector to the boost control solenoid or actuator; failed boost control solenoid or electronic actuator; blown fuse or poor power feed; engine computer driver fault. A shop should confirm the cause before replacing parts.