Home › Code lookup › P004E
Powertrain code · Fuel and air

P004E Turbocharger/Supercharger Boost Control "A" Circuit Intermittent/Erratic

How urgent? Get it checked in the next few days

What it means

The boost control system (usually a wastegate or variable vane actuator) sets how much pressure the turbo or supercharger makes. The computer found a signal that keeps cutting in and out in the "A" boost control circuit.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the boost control solenoid or actuator connector and wiring
  2. Measure the solenoid resistance and compare to spec
  3. Command the actuator with a scan tool and watch it move

Signs you may notice

  • Check engine light on
  • Loss of power or slow acceleration
  • Engine may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged wiring or loose connector to the boost control solenoid or actuator
  • CommonFailed boost control solenoid or electronic actuator
  • PossibleBlown fuse or poor power feed
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a wiring repair or a new boost control solenoid or actuator.

Repair costInsufficient verified pricing for this vehicle and repair
Replace boost control solenoid. Prepare an itemized shop request.
Walk through it step by step: Car has no power when accelerating →

Common questions

What does P004E mean?

The boost control system (usually a wastegate or variable vane actuator) sets how much pressure the turbo or supercharger makes. The computer found a signal that keeps cutting in and out in the "A" boost control circuit.

Can I drive with code P004E?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P004E?

Common possibilities to test include: damaged wiring or loose connector to the boost control solenoid or actuator; failed boost control solenoid or electronic actuator; blown fuse or poor power feed; engine computer driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.