Home › Code lookup › P005D
Powertrain code · Engine

P005D "B" Camshaft Profile Control Stuck On (Bank 2)

How urgent? Book a check when convenient

What it means

Some engines can switch between two camshaft lobe shapes. On bank 2, the computer found the "B" cam switching system stuck in its switched-on position.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and condition
  2. Check oil pressure
  3. Inspect the switching solenoid and its screen for sludge

Signs you may notice

  • Check engine light on
  • Rough idle or poor low-speed running
  • Possible lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow, dirty or wrong-grade engine oil
  • CommonSticking cam profile switching solenoid
  • PossibleLow oil pressure to the switching mechanism
  • PossibleWorn or sticking cam follower or locking pin

Typical repair once the cause is confirmed

Often an oil change and a new switching solenoid. Mechanical wear inside the valvetrain is less common.

Walk through it step by step: Check engine light on →

Common questions

What does P005D mean?

Some engines can switch between two camshaft lobe shapes. On bank 2, the computer found the "B" cam switching system stuck in its switched-on position.

Can I drive with code P005D?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P005D?

Common possibilities to test include: low, dirty or wrong-grade engine oil; sticking cam profile switching solenoid; low oil pressure to the switching mechanism; worn or sticking cam follower or locking pin. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.