Home › Code lookup › P0061
Powertrain code · Emissions

P0061 HO2S Heater Resistance (Bank 2 Sensor 3)

How urgent? Book a check when convenient

What it means

The computer checks the resistance of the heater inside each oxygen sensor. The heater in the third, furthest-downstream sensor on bank 2 measured outside its normal range.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector and wiring
  2. Measure the heater resistance and compare to spec
  3. Make sure any replacement sensor is the correct part for the vehicle

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions or readiness test

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn or failed heater inside the oxygen sensor
  • PossibleWrong or aftermarket sensor with a different heater rating
  • PossibleHigh resistance from a corroded connector or damaged wiring

Typical repair once the cause is confirmed

Usually a new oxygen sensor of the correct type.

Repair costInsufficient verified pricing for this vehicle and repair
Replace downstream oxygen sensor. Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0061 mean?

The computer checks the resistance of the heater inside each oxygen sensor. The heater in the third, furthest-downstream sensor on bank 2 measured outside its normal range.

Can I drive with code P0061?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0061?

Common possibilities to test include: worn or failed heater inside the oxygen sensor; wrong or aftermarket sensor with a different heater rating; high resistance from a corroded connector or damaged wiring. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.