Home › Code lookup › P0068
Powertrain code · Fuel and air

P0068 MAP/MAF - Throttle Position Correlation

How urgent? Get it checked in the next few days

What it means

The computer compares how much air the engine is taking in (from the MAF or MAP sensor) with how far the throttle is open. Those readings do not agree, so it suspects an air leak or a bad sensor.

Can I keep driving?

If the car idles and drives normally, get it checked within a few days. If it stalls when slowing down, surges, or drops into reduced power mode, limit driving and avoid highways; a stall makes steering and braking much harder and loss of power is risky when merging.

What to test before replacing parts

Smoke test for intake leaks after the throttle, compare MAF, MAP and throttle position readings on a scan tool, and inspect throttle body and MAF wiring before replacing parts.

  1. Check intake hoses, PCV hose and vacuum lines for cracks or leaks
  2. Inspect and clean the MAF sensor and throttle body
  3. Compare MAF, MAP and throttle readings at idle and under load with a scan tool

Signs you may notice

  • Check engine light on
  • Rough or unstable idle
  • Hesitation or stalling, especially when slowing down
  • Possible reduced power mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonVacuum or intake air leak after the throttle
  • CommonDirty or faulty mass air flow (MAF) sensor
  • CommonDirty or failing electronic throttle body
  • PossibleFaulty MAP sensor or cracked MAP hose
  • PossibleWiring problem at the throttle body or MAF sensor

Typical repair once the cause is confirmed

Often fixing a vacuum leak or cleaning the throttle body and MAF sensor. If that fails, a new throttle body or MAF sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace electronic throttle body. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Engine dies when stopping →

Common questions

What does P0068 mean?

The computer compares how much air the engine is taking in (from the MAF or MAP sensor) with how far the throttle is open. Those readings do not agree, so it suspects an air leak or a bad sensor.

Can I drive with code P0068?

If the car idles and drives normally, get it checked within a few days. If it stalls when slowing down, surges, or drops into reduced power mode, limit driving and avoid highways; a stall makes steering and braking much harder and loss of power is risky when merging.

What causes P0068?

Common possibilities to test include: vacuum or intake air leak after the throttle; dirty or faulty mass air flow (maf) sensor; dirty or failing electronic throttle body; faulty map sensor or cracked map hose. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.