Home › Code lookup › P006E
Powertrain code · Fuel and air

P006E Turbocharger/Supercharger Boost Control "A" Supply Voltage Circuit Low

How urgent? Get it checked in the next few days

What it means

The "A" boost control actuator needs a steady power supply to work. The computer found that the supply voltage to it is too low.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the fuse and relay feeding the actuator
  2. Measure supply voltage at the actuator connector
  3. Inspect the wiring harness for damage

Signs you may notice

  • Check engine light on
  • Loss of power or limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBlown fuse or failed relay for the actuator
  • CommonDamaged power or ground wiring
  • PossibleCorroded connector
  • PossibleWeak battery or charging problem

Typical repair once the cause is confirmed

Usually a fuse, relay or wiring repair; sometimes a new boost actuator.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P006E mean?

The "A" boost control actuator needs a steady power supply to work. The computer found that the supply voltage to it is too low.

Can I drive with code P006E?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P006E?

Common possibilities to test include: blown fuse or failed relay for the actuator; damaged power or ground wiring; corroded connector; weak battery or charging problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.