Home › Code lookup › P0084
Powertrain code · Engine

P0084 Exhaust Valve Control Solenoid Circuit (Bank 2)

How urgent? Get it checked in the next few days

What it means

The exhaust valve control solenoid on bank 2 is an electric valve that adjusts valve timing or lift using oil pressure. The computer found a fault, such as an open circuit, in its circuit.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the solenoid connector and wiring
  2. Measure the solenoid resistance and compare to spec
  3. Command the solenoid with a scan tool and check for a response

Signs you may notice

  • Check engine light on
  • Rough idle or stalling
  • Reduced power and fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed valve control solenoid
  • CommonDamaged wiring or loose connector at the solenoid
  • PossibleOil leaking into the connector
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a new valve control solenoid or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace valve control solenoid. Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0084 mean?

The exhaust valve control solenoid on bank 2 is an electric valve that adjusts valve timing or lift using oil pressure. The computer found a fault, such as an open circuit, in its circuit.

Can I drive with code P0084?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0084?

Common possibilities to test include: failed valve control solenoid; damaged wiring or loose connector at the solenoid; oil leaking into the connector; engine computer driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.