P00AF Turbocharger/Supercharger Boost Control "A" Module Performance
What it means
Some turbos use an electronic actuator with its own small control module to move the wastegate or variable vanes. The computer found that the "A" actuator module is not performing correctly.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check for other actuator or network codes
- Inspect the actuator wiring and connector
- Run the actuator self-test or relearn with a scan tool
Signs you may notice
- Check engine light on
- Loss of power or limp mode
- Possible slow boost build-up
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed electronic boost actuator or its module
- CommonSticking wastegate or vane mechanism overloading the actuator
- PossiblePower, ground or network wiring problem to the actuator
- PossibleActuator not calibrated after replacement
Typical repair once the cause is confirmed
Often a new electronic boost actuator, which sometimes comes only with the turbo. Check for a sticking mechanism first.
Known on these vehicles
Common questions
What does P00AF mean?
Some turbos use an electronic actuator with its own small control module to move the wastegate or variable vanes. The computer found that the "A" actuator module is not performing correctly.
Can I drive with code P00AF?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P00AF?
Common possibilities to test include: failed electronic boost actuator or its module; sticking wastegate or vane mechanism overloading the actuator; power, ground or network wiring problem to the actuator; actuator not calibrated after replacement. A shop should confirm the cause before replacing parts.