Home › Code lookup › P00B0
Powertrain code · Fuel and air

P00B0 Turbocharger/Supercharger Boost Control "B" Module Performance

How urgent? Get it checked in the next few days

What it means

Some turbos use an electronic actuator with its own small control module to move the wastegate or variable vanes. The computer found that the "B" actuator module is not performing correctly.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other actuator or network codes
  2. Inspect the actuator wiring and connector
  3. Run the actuator self-test or relearn with a scan tool

Signs you may notice

  • Check engine light on
  • Loss of power or limp mode
  • Possible slow boost build-up

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed electronic boost actuator or its module
  • CommonSticking wastegate or vane mechanism overloading the actuator
  • PossiblePower, ground or network wiring problem to the actuator
  • PossibleActuator not calibrated after replacement

Typical repair once the cause is confirmed

Often a new electronic boost actuator, which sometimes comes only with the turbo. Check for a sticking mechanism first.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P00B0 mean?

Some turbos use an electronic actuator with its own small control module to move the wastegate or variable vanes. The computer found that the "B" actuator module is not performing correctly.

Can I drive with code P00B0?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P00B0?

Common possibilities to test include: failed electronic boost actuator or its module; sticking wastegate or vane mechanism overloading the actuator; power, ground or network wiring problem to the actuator; actuator not calibrated after replacement. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.