P00BD Mass or Volume Air Flow "A" Circuit Range/Performance - Air Flow Too High
What it means
The mass air flow sensor measures how much air the engine takes in. The computer compared the "A" sensor reading with what it expected and found the measured air flow is too high.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the air filter and intake ducts
- Clean the MAF sensor with MAF-safe cleaner
- Compare MAF readings to expected values with a scan tool
Signs you may notice
- Check engine light on
- Hesitation, rough idle or stalling
- Possible reduced power or poor fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty or contaminated MAF sensor
- PossibleWrong or oiled aftermarket air filter fouling the sensor
- PossibleWiring problem at the MAF sensor
- PossibleBoost or intake system problem
Typical repair once the cause is confirmed
Often cleaning the MAF sensor or fixing an air leak; otherwise a new MAF sensor.
Common questions
What does P00BD mean?
The mass air flow sensor measures how much air the engine takes in. The computer compared the "A" sensor reading with what it expected and found the measured air flow is too high.
Can I drive with code P00BD?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P00BD?
Common possibilities to test include: faulty or contaminated maf sensor; wrong or oiled aftermarket air filter fouling the sensor; wiring problem at the maf sensor; boost or intake system problem. A shop should confirm the cause before replacing parts.