Home › Code lookup › P00BE
Powertrain code · Fuel and air

P00BE Mass or Volume Air Flow "B" Circuit Range/Performance - Air Flow Too Low

How urgent? Get it checked in the next few days

What it means

The mass air flow sensor measures how much air the engine takes in. The computer compared the "B" sensor reading with what it expected and found the measured air flow is too low.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the air filter and intake ducts
  2. Clean the MAF sensor with MAF-safe cleaner
  3. Compare MAF readings to expected values with a scan tool

Signs you may notice

  • Check engine light on
  • Hesitation, rough idle or stalling
  • Possible reduced power or poor fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDirty or contaminated MAF sensor
  • CommonIntake air leak after the MAF sensor
  • CommonClogged air filter or restricted intake
  • PossibleFaulty MAF sensor or wiring

Typical repair once the cause is confirmed

Often cleaning the MAF sensor or fixing an air leak; otherwise a new MAF sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace mass air flow sensor. Prepare an itemized shop request.
Walk through it step by step: Hesitation when accelerating →

Common questions

What does P00BE mean?

The mass air flow sensor measures how much air the engine takes in. The computer compared the "B" sensor reading with what it expected and found the measured air flow is too low.

Can I drive with code P00BE?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P00BE?

Common possibilities to test include: dirty or contaminated maf sensor; intake air leak after the maf sensor; clogged air filter or restricted intake; faulty maf sensor or wiring. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.