P0659 Actuator Supply Voltage "A" Circuit High
What it means
The power feed the computer uses for parts like injectors, solenoids and valves (supply "A") is too high.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check fuses and relays that feed the engine actuators
- Inspect the harness for chafing or melted wires
- Unplug actuators one at a time to find a short
Signs you may notice
- Check engine light on
- Stalling, no start or limp mode
- Several other codes may set at once
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSupply wire shorted to another voltage source
- CommonFaulty relay stuck on
- PossibleComputer fault (rare)
Typical repair once the cause is confirmed
Usually a fuse or relay, a wiring repair, or a shorted part.
Common questions
What does P0659 mean?
The power feed the computer uses for parts like injectors, solenoids and valves (supply "A") is too high.
Can I drive with code P0659?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0659?
Common possibilities to test include: supply wire shorted to another voltage source; faulty relay stuck on; computer fault (rare). A shop should confirm the cause before replacing parts.