Home › Code lookup › P2100
Powertrain code · Speed and idle control

P2100 Throttle Actuator Control Motor Circuit/Open

How urgent? Get it checked in the next few days

What it means

The engine computer can't properly control the electronic throttle motor, which opens and closes the throttle when you press the gas pedal. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the throttle body connector and wiring
  2. Check for power at the connector and measure the part's resistance

Signs you may notice

  • Check engine light on
  • Reduced engine power or limp mode
  • Poor idle or slow response to the gas pedal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed electronic throttle body
  • CommonBroken wire or unplugged connector
  • PossibleBlown fuse or bad relay feeding the circuit
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the electronic throttle body.

Repair costInsufficient verified pricing for this vehicle and repair
Replace electronic throttle body. Prepare an itemized shop request.
Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2100 mean?

The engine computer can't properly control the electronic throttle motor, which opens and closes the throttle when you press the gas pedal. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I drive with code P2100?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2100?

Common possibilities to test include: failed electronic throttle body; broken wire or unplugged connector; blown fuse or bad relay feeding the circuit; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.