P2103 Throttle Actuator Control Motor Circuit High
What it means
The control circuit for the electronic throttle motor is reading high voltage. This part opens and closes the throttle when you press the gas pedal. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the throttle body wiring for shorts to other wires
- Measure the throttle body resistance and compare with spec
Signs you may notice
- Check engine light on
- Reduced engine power or limp mode
- Poor idle or slow response to the gas pedal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed electronic throttle body
- CommonControl wire shorted to a power source
- PossibleOpen circuit or corroded connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the electronic throttle body.
Common questions
What does P2103 mean?
The control circuit for the electronic throttle motor is reading high voltage. This part opens and closes the throttle when you press the gas pedal. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I drive with code P2103?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2103?
Common possibilities to test include: failed electronic throttle body; control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.