Home › Code lookup › P2102
Powertrain code · Speed and idle control

P2102 Throttle Actuator Control Motor Circuit Low

How urgent? Get it checked in the next few days

What it means

The control circuit for the electronic throttle motor is reading low voltage. This part opens and closes the throttle when you press the gas pedal. A wire shorted to ground or a shorted part is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the throttle body wiring for rubbed-through insulation
  2. Measure the throttle body resistance and compare with spec

Signs you may notice

  • Check engine light on
  • Reduced engine power or limp mode
  • Poor idle or slow response to the gas pedal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire shorted to ground
  • CommonInternally shorted electronic throttle body
  • PossibleDamaged connector
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the electronic throttle body.

Repair costInsufficient verified pricing for this vehicle and repair
Replace electronic throttle body. Prepare an itemized shop request.
Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2102 mean?

The control circuit for the electronic throttle motor is reading low voltage. This part opens and closes the throttle when you press the gas pedal. A wire shorted to ground or a shorted part is the usual reason.

Can I drive with code P2102?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2102?

Common possibilities to test include: control wire shorted to ground; internally shorted electronic throttle body; damaged connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.