Home › Code lookup › P2400
Powertrain code · Emissions

P2400 Evaporative Emission System Leak Detection Pump Control Circuit/Open

How urgent? Book a check when convenient

What it means

The engine computer can't properly control the EVAP leak detection pump, which pressurizes or pulls vacuum on the fuel vapor system to test it for leaks. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the leak detection pump connector and wiring
  2. Check for power at the connector and measure the part's resistance

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions inspection

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed EVAP leak detection pump
  • CommonBroken wire or unplugged connector
  • PossibleBlown fuse or bad relay feeding the circuit
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the EVAP leak detection pump.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EVAP leak detection pump. Prepare an itemized shop request.

Where it shows up

  • Leak detection pumps like this are used on many Chrysler, Dodge and Jeep vehicles

Common questions

What does P2400 mean?

The engine computer can't properly control the EVAP leak detection pump, which pressurizes or pulls vacuum on the fuel vapor system to test it for leaks. It sees an open or broken circuit, often from wiring, a connector or the part itself.

Can I drive with code P2400?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2400?

Common possibilities to test include: failed evap leak detection pump; broken wire or unplugged connector; blown fuse or bad relay feeding the circuit; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.