Home › Code lookup › P2403
Powertrain code · Emissions

P2403 Evaporative Emission System Leak Detection Pump Sense Circuit/Open

How urgent? Book a check when convenient

What it means

The engine computer has found a problem in the circuit for the EVAP leak detection pump sense circuit, which reports back to the computer whether the leak detection pump is working. It usually points to wiring, a connector or the sensor itself.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the leak detection pump connector and wiring for damage or corrosion
  2. Check the sensor power, ground and signal with a meter

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions inspection

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty EVAP leak detection pump
  • CommonDamaged, corroded or unplugged connector
  • PossibleBroken or chafed wiring
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the EVAP leak detection pump.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EVAP leak detection pump. Prepare an itemized shop request.

Where it shows up

  • Leak detection pumps like this are used on many Chrysler, Dodge and Jeep vehicles

Common questions

What does P2403 mean?

The engine computer has found a problem in the circuit for the EVAP leak detection pump sense circuit, which reports back to the computer whether the leak detection pump is working. It usually points to wiring, a connector or the sensor itself.

Can I drive with code P2403?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2403?

Common possibilities to test include: faulty evap leak detection pump; damaged, corroded or unplugged connector; broken or chafed wiring; engine computer problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.