Home › Code lookup › P2407
Powertrain code · Emissions

P2407 Evaporative Emission System Leak Detection Pump Sense Circuit Intermittent/Erratic

How urgent? Book a check when convenient

What it means

The signal from the EVAP leak detection pump sense circuit keeps dropping out or jumping around. This sensor reports back to the computer whether the leak detection pump is working. A loose connection or a damaged wire is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the harness and connector while watching live data for dropouts
  2. Inspect the leak detection pump wiring along its whole route

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions inspection

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded connector
  • CommonChafed wire that opens or shorts as the engine moves
  • PossibleFailing EVAP leak detection pump

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the EVAP leak detection pump.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EVAP leak detection pump. Prepare an itemized shop request.

Where it shows up

  • Leak detection pumps like this are used on many Chrysler, Dodge and Jeep vehicles

Common questions

What does P2407 mean?

The signal from the EVAP leak detection pump sense circuit keeps dropping out or jumping around. This sensor reports back to the computer whether the leak detection pump is working. A loose connection or a damaged wire is the usual reason.

Can I drive with code P2407?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2407?

Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing evap leak detection pump. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.