P2405 Evaporative Emission System Leak Detection Pump Sense Circuit Low
What it means
The signal from the EVAP leak detection pump sense circuit is lower than the computer expects. This sensor reports back to the computer whether the leak detection pump is working. A wire shorted to ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the leak detection pump wiring for rubbed-through or pinched spots
- Unplug the sensor and see if the reading changes, which helps separate wiring from sensor
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
- May fail an emissions inspection
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal or reference wire shorted to ground
- CommonFailed EVAP leak detection pump
- PossibleCorroded or damaged connector
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the EVAP leak detection pump.
Where it shows up
- Leak detection pumps like this are used on many Chrysler, Dodge and Jeep vehicles
Common questions
What does P2405 mean?
The signal from the EVAP leak detection pump sense circuit is lower than the computer expects. This sensor reports back to the computer whether the leak detection pump is working. A wire shorted to ground or a failed sensor is the usual reason.
Can I drive with code P2405?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2405?
Common possibilities to test include: signal or reference wire shorted to ground; failed evap leak detection pump; corroded or damaged connector; engine computer problem (rare). A shop should confirm the cause before replacing parts.