Home › Code lookup › P2401
Powertrain code · Emissions

P2401 Evaporative Emission System Leak Detection Pump Control Circuit Low

How urgent? Book a check when convenient

What it means

The control circuit for the EVAP leak detection pump is reading low voltage. This part pressurizes or pulls vacuum on the fuel vapor system to test it for leaks. A wire shorted to ground or a shorted part is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the leak detection pump wiring for rubbed-through insulation
  2. Measure the leak detection pump resistance and compare with spec

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions inspection

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire shorted to ground
  • CommonInternally shorted EVAP leak detection pump
  • PossibleDamaged connector
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the EVAP leak detection pump.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EVAP leak detection pump. Prepare an itemized shop request.

Where it shows up

  • Leak detection pumps like this are used on many Chrysler, Dodge and Jeep vehicles

Common questions

What does P2401 mean?

The control circuit for the EVAP leak detection pump is reading low voltage. This part pressurizes or pulls vacuum on the fuel vapor system to test it for leaks. A wire shorted to ground or a shorted part is the usual reason.

Can I drive with code P2401?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2401?

Common possibilities to test include: control wire shorted to ground; internally shorted evap leak detection pump; damaged connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.