P2404 Evaporative Emission System Leak Detection Pump Sense Circuit Range/Performance
What it means
The EVAP leak detection pump sense circuit is giving readings that don't make sense compared with what the computer expects. This sensor reports back to the computer whether the leak detection pump is working. The sensor may be failing or the system it watches may have a real problem.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the leak detection pump reading with related sensors in live data
- Check wiring and connector for corrosion or looseness
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
- May fail an emissions inspection
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing or out-of-calibration EVAP leak detection pump
- CommonLeak detection pump stuck, or a blocked or leaking EVAP hose
- PossibleHigh resistance in the wiring or connector
Typical repair once the cause is confirmed
Confirm the system itself is working, then replace the EVAP leak detection pump if its readings are off.
Where it shows up
- Leak detection pumps like this are used on many Chrysler, Dodge and Jeep vehicles
Common questions
What does P2404 mean?
The EVAP leak detection pump sense circuit is giving readings that don't make sense compared with what the computer expects. This sensor reports back to the computer whether the leak detection pump is working. The sensor may be failing or the system it watches may have a real problem.
Can I drive with code P2404?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2404?
Common possibilities to test include: failing or out-of-calibration evap leak detection pump; leak detection pump stuck, or a blocked or leaking evap hose; high resistance in the wiring or connector. A shop should confirm the cause before replacing parts.