Home › Code lookup › P2800
Powertrain code · Transmission

P2800 Transmission Range Sensor "B" Circuit (PRNDL Input)

How urgent? Get it checked in the next few days

What it means

The computer is watching the transmission range sensor "B" circuit and has spotted an electrical fault. This sensor tells the computers which gear position (P, R, N, D) the shifter is in.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the transmission range sensor "B" circuit, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • Gear indicator may show the wrong gear
  • May not start in Park or Neutral
  • Harsh or wrong shifts possible

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonRange sensor out of adjustment or worn
  • CommonUnplugged, loose or corroded connector at the transmission range sensor
  • CommonBroken or chafed wire in the transmission range sensor "B" circuit
  • CommonFailed transmission range sensor
  • PossibleMissing reference voltage or ground from the computer

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the transmission range sensor.

Walk through it step by step: Car won't start →

Common questions

What does P2800 mean?

The computer is watching the transmission range sensor "B" circuit and has spotted an electrical fault. This sensor tells the computers which gear position (P, R, N, D) the shifter is in.

Can I drive with code P2800?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2800?

Common possibilities to test include: range sensor out of adjustment or worn; unplugged, loose or corroded connector at the transmission range sensor; broken or chafed wire in the transmission range sensor "b" circuit; failed transmission range sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.