Home › Code lookup › P2805
Powertrain code · Transmission

P2805 Transmission Range Sensor "A"/"B" Correlation

How urgent? Get it checked in the next few days

What it means

The two signals from the gear position sensor do not agree about which gear position is selected.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check that the shifter and gear indicator match
  2. Check range sensor readings in each position

Signs you may notice

  • Check engine light on
  • Gear indicator may show the wrong gear
  • May not start in Park or Neutral
  • Harsh or wrong shifts possible

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn or failing transmission range sensor
  • CommonShift cable out of adjustment
  • PossibleWiring or connector fault
  • PossibleTransmission computer fault

Typical repair once the cause is confirmed

Adjust or replace the range sensor, or adjust the shift cable.

Walk through it step by step: Car won't start →

Common questions

What does P2805 mean?

The two signals from the gear position sensor do not agree about which gear position is selected.

Can I drive with code P2805?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2805?

Common possibilities to test include: worn or failing transmission range sensor; shift cable out of adjustment; wiring or connector fault; transmission computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.