Home › Code lookup › P2803
Powertrain code · Transmission

P2803 Transmission Range Sensor "B" Circuit High

How urgent? Get it checked in the next few days

What it means

The computer is watching the transmission range sensor "B" circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor tells the computers which gear position (P, R, N, D) the shifter is in.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and ground connection for the transmission range sensor "B" circuit
  2. Check for wires melted or rubbed together in the harness
  3. Measure the circuit with a meter before replacing parts

Signs you may notice

  • Check engine light on
  • Gear indicator may show the wrong gear
  • May not start in Park or Neutral
  • Harsh or wrong shifts possible

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonRange sensor out of adjustment or worn
  • CommonSignal wire shorted to voltage or a broken ground wire
  • CommonFailed transmission range sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the open ground or shorted wire; if the wiring is fine, replace the transmission range sensor.

Walk through it step by step: Car won't start →

Common questions

What does P2803 mean?

The computer is watching the transmission range sensor "B" circuit and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor tells the computers which gear position (P, R, N, D) the shifter is in.

Can I drive with code P2803?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2803?

Common possibilities to test include: range sensor out of adjustment or worn; signal wire shorted to voltage or a broken ground wire; failed transmission range sensor; corroded or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.