Home › Code lookup › P2802
Powertrain code · Transmission

P2802 Transmission Range Sensor "B" Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer is watching the transmission range sensor "B" circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This sensor tells the computers which gear position (P, R, N, D) the shifter is in.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring in the transmission range sensor "B" circuit for rubbed-through insulation touching metal
  2. Unplug the transmission range sensor and see if the reading changes
  3. Clear the code and see if it returns right away

Signs you may notice

  • Check engine light on
  • Gear indicator may show the wrong gear
  • May not start in Park or Neutral
  • Harsh or wrong shifts possible

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonRange sensor out of adjustment or worn
  • CommonSignal wire in the transmission range sensor "B" circuit shorted to ground or open
  • CommonFailed transmission range sensor
  • PossibleCorroded or loose connector
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Fix any shorted wiring first; if the wiring tests good, replace the transmission range sensor.

Walk through it step by step: Car won't start →

Common questions

What does P2802 mean?

The computer is watching the transmission range sensor "B" circuit and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This sensor tells the computers which gear position (P, R, N, D) the shifter is in.

Can I drive with code P2802?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2802?

Common possibilities to test include: range sensor out of adjustment or worn; signal wire in the transmission range sensor "b" circuit shorted to ground or open; failed transmission range sensor; corroded or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.