Home › Code lookup › P280A
Powertrain code · Transmission

P280A Transmission Range Sensor "A" Circuit Not Learned

How urgent? Get it checked in the next few days

What it means

The computer has not learned the positions of gear position sensor "A", usually after a part was replaced.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Ask whether parts were recently replaced
  2. Run the range sensor learn procedure with a scan tool

Signs you may notice

  • Check engine light on
  • Gear indicator may show the wrong gear
  • May not start in Park or Neutral
  • Harsh or wrong shifts possible

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonRelearn not done after replacing the sensor, transmission or computer
  • CommonRelearn procedure interrupted
  • PossibleFaulty range sensor

Typical repair once the cause is confirmed

Perform the range sensor learn procedure.

Walk through it step by step: Car won't start →

Common questions

What does P280A mean?

The computer has not learned the positions of gear position sensor "A", usually after a part was replaced.

Can I drive with code P280A?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P280A?

Common possibilities to test include: relearn not done after replacing the sensor, transmission or computer; relearn procedure interrupted; faulty range sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.