Home › Code lookup › P2804
Powertrain code · Transmission

P2804 Transmission Range Sensor "B" Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

The computer is watching the transmission range sensor "B" circuit and is seeing a signal that cuts in and out. This sensor tells the computers which gear position (P, R, N, D) the shifter is in.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the wiring for the transmission range sensor "B" circuit with the engine running while watching live data
  2. Check connector pins for corrosion or spread terminals
  3. Note when it happens (hot, cold, bumps) to narrow it down

Signs you may notice

  • Check engine light on
  • Gear indicator may show the wrong gear
  • May not start in Park or Neutral
  • Harsh or wrong shifts possible

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonRange sensor out of adjustment or worn
  • CommonLoose connector or chafed wire that loses contact over bumps
  • CommonTransmission range sensor failing on and off
  • PossibleCorrosion inside the connector
  • PossiblePoor ground connection

Typical repair once the cause is confirmed

Repair the loose or corroded connection; replace the transmission range sensor if the wiring is solid.

Walk through it step by step: Car won't start →

Common questions

What does P2804 mean?

The computer is watching the transmission range sensor "B" circuit and is seeing a signal that cuts in and out. This sensor tells the computers which gear position (P, R, N, D) the shifter is in.

Can I drive with code P2804?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2804?

Common possibilities to test include: range sensor out of adjustment or worn; loose connector or chafed wire that loses contact over bumps; transmission range sensor failing on and off; corrosion inside the connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.