Home › Code lookup › U0413
Network code · Network

U0413 Invalid Data Received From Battery Energy Control Module "B"

How urgent? Get it checked in the next few days

What it means

Another module received a message from the second hybrid battery control module that does not make sense, such as a value that is out of range or does not add up. It is part of the hybrid or electric drive system.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the second hybrid battery control module for its own stored codes and fix those first
  2. Test the battery and grounds
  3. Check for software updates or service bulletins

Signs you may notice

  • Hybrid or EV system warning on
  • Car may not go into Ready mode or may lose power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty sensor or input feeding the second hybrid battery control module
  • CommonThe second hybrid battery control module needs a software update
  • CommonLow battery voltage or poor ground causing bad messages
  • PossibleNetwork wiring problem or interference
  • PossibleFailed second hybrid battery control module

Typical repair once the cause is confirmed

Fix any fault in the second hybrid battery control module or its sensors, then update the software if needed.

Walk through it step by step: Check hybrid system warning →

Common questions

What does U0413 mean?

Another module received a message from the second hybrid battery control module that does not make sense, such as a value that is out of range or does not add up. It is part of the hybrid or electric drive system.

Can I drive with code U0413?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0413?

Common possibilities to test include: faulty sensor or input feeding the second hybrid battery control module; the second hybrid battery control module needs a software update; low battery voltage or poor ground causing bad messages; network wiring problem or interference. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.