Home › Code lookup › U0420
Network code · Network

U0420 Invalid Data Received From Power Steering Control Module

How urgent? Get it checked in the next few days

What it means

Another module received a message from the power steering control module that does not make sense, such as a value that is out of range or does not add up. It is part of the steering system.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the power steering control module for its own stored codes and fix those first
  2. Test the battery and grounds
  3. Check for software updates or service bulletins

Signs you may notice

  • Power steering or steering warning light on
  • Steering may feel heavy
  • Stability control may be turned off

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSteering angle or torque sensor needing calibration
  • CommonThe power steering control module needs a software update
  • CommonLow battery voltage or poor ground causing bad messages
  • PossibleNetwork wiring problem or interference
  • PossibleFailed power steering control module

Typical repair once the cause is confirmed

Fix any fault in the power steering control module or its sensors, then update the software if needed.

Walk through it step by step: Power steering warning light on →

Common questions

What does U0420 mean?

Another module received a message from the power steering control module that does not make sense, such as a value that is out of range or does not add up. It is part of the steering system.

Can I drive with code U0420?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0420?

Common possibilities to test include: steering angle or torque sensor needing calibration; the power steering control module needs a software update; low battery voltage or poor ground causing bad messages; network wiring problem or interference. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.