U0426 Invalid Data Received From Vehicle Immobilizer Control Module
What it means
Another module received a message from the immobilizer module that does not make sense, such as a value that is out of range or does not add up. It is part of the anti-theft system that checks the key before the engine can run.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the immobilizer module for its own stored codes and fix those first
- Test the battery and grounds
- Check for software updates or service bulletins
Signs you may notice
- Security light on or flashing
- Car may crank but not start
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonKey not programmed or a weak key chip
- CommonThe immobilizer module needs a software update
- CommonLow battery voltage or poor ground causing bad messages
- PossibleNetwork wiring problem or interference
- PossibleFailed immobilizer module
Typical repair once the cause is confirmed
Fix any fault in the immobilizer module or its sensors, then update the software if needed.
Common questions
What does U0426 mean?
Another module received a message from the immobilizer module that does not make sense, such as a value that is out of range or does not add up. It is part of the anti-theft system that checks the key before the engine can run.
Can I drive with code U0426?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0426?
Common possibilities to test include: key not programmed or a weak key chip; the immobilizer module needs a software update; low battery voltage or poor ground causing bad messages; network wiring problem or interference. A shop should confirm the cause before replacing parts.