Home › Code lookup › U0428
Network code · Network

U0428 Invalid Data Received From Steering Angle Sensor Module

How urgent? Get it checked in the next few days

What it means

Another module received a message from the steering angle sensor that does not make sense, such as a value that is out of range or does not add up. It is part of the anti-lock brake and stability control system.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the steering angle sensor for its own stored codes and fix those first
  2. Test the battery and grounds
  3. Check for software updates or service bulletins

Signs you may notice

  • ABS, traction control or stability light on
  • ABS and stability control may be turned off
  • Normal braking usually still works

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSteering angle sensor not calibrated after an alignment or repair
  • CommonThe steering angle sensor needs a software update
  • CommonLow battery voltage or poor ground causing bad messages
  • PossibleNetwork wiring problem or interference
  • PossibleFailed steering angle sensor

Typical repair once the cause is confirmed

Fix any fault in the steering angle sensor or its sensors, then update the software if needed.

Walk through it step by step: ABS light on →

Common questions

What does U0428 mean?

Another module received a message from the steering angle sensor that does not make sense, such as a value that is out of range or does not add up. It is part of the anti-lock brake and stability control system.

Can I drive with code U0428?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0428?

Common possibilities to test include: steering angle sensor not calibrated after an alignment or repair; the steering angle sensor needs a software update; low battery voltage or poor ground causing bad messages; network wiring problem or interference. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.