Home › Code lookup › P0019
Powertrain code · Engine

P0019 Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor B)

How urgent? Get it checked in the next few days

What it means

The crankshaft and camshaft must stay in exact step. The computer compared their sensor signals and found the timing between the crank and the "B" (usually exhaust) camshaft on bank 2 is out of the expected range.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and condition
  2. Check the sensor wiring and connectors
  3. Have a shop check cam/crank sync with a scope or scan tool before replacing the timing chain

Signs you may notice

  • Check engine light on
  • Hard starting or long cranking
  • Rough idle, misfire or loss of power
  • Rattle from the timing chain area at startup

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonStretched timing chain or worn chain tensioner
  • CommonTiming chain or belt jumped a tooth
  • CommonFaulty camshaft or crankshaft position sensor
  • PossibleSticking oil control valve or worn cam phaser
  • PossibleDamaged reluctor (tone) ring or sensor wiring problem

Typical repair once the cause is confirmed

Often a timing chain, tensioner and guides. Sometimes it is just a camshaft or crankshaft sensor, so test before replacing major parts.

Repair costInsufficient verified pricing for this vehicle and repair
Replace timing chain set. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Hard to start when cold →

Common questions

What does P0019 mean?

The crankshaft and camshaft must stay in exact step. The computer compared their sensor signals and found the timing between the crank and the "B" (usually exhaust) camshaft on bank 2 is out of the expected range.

Can I drive with code P0019?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0019?

Common possibilities to test include: stretched timing chain or worn chain tensioner; timing chain or belt jumped a tooth; faulty camshaft or crankshaft position sensor; sticking oil control valve or worn cam phaser. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.