Home › Code lookup › P0038
Powertrain code · Emissions

P0038 HO2S Heater Control Circuit High (Bank 1 Sensor 2)

How urgent? Book a check when convenient

What it means

Oxygen sensors have a built-in heater so they start working soon after a cold start. The computer found a voltage that is too high in the heater circuit of the downstream (after the catalytic converter) oxygen sensor on bank 1.

Can I keep driving?

Usually you can keep driving normally and schedule a repair; the heater only helps the oxygen sensor warm up quickly. Get it checked sooner if the engine starts running rough, other codes appear, or you smell fuel. The car may not pass an emissions or inspection test until it's fixed.

What to test before replacing parts

Check the O2 heater fuse first, then measure heater resistance and check power and ground at the connector. Inspect the wiring under the car for damage before replacing the sensor.

  1. Check the oxygen sensor heater fuse
  2. Inspect the sensor wiring for melted or rubbed-through spots near the exhaust
  3. Measure the heater resistance at the sensor and compare to spec

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions or readiness test

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed heater inside the oxygen sensor
  • CommonBlown fuse for the oxygen sensor heaters
  • CommonDamaged or melted wiring near the exhaust
  • PossibleCorroded or loose sensor connector
  • PossibleEngine computer heater driver fault

Typical repair once the cause is confirmed

Most often a new oxygen sensor. If the fuse is blown, find the short that blew it before replacing the sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace downstream oxygen sensor. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P0038 mean?

Oxygen sensors have a built-in heater so they start working soon after a cold start. The computer found a voltage that is too high in the heater circuit of the downstream (after the catalytic converter) oxygen sensor on bank 1.

Can I drive with code P0038?

Usually you can keep driving normally and schedule a repair; the heater only helps the oxygen sensor warm up quickly. Get it checked sooner if the engine starts running rough, other codes appear, or you smell fuel. The car may not pass an emissions or inspection test until it's fixed.

What causes P0038?

Common possibilities to test include: failed heater inside the oxygen sensor; blown fuse for the oxygen sensor heaters; damaged or melted wiring near the exhaust; corroded or loose sensor connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.