Home › Code lookup › P0091
Powertrain code · Fuel and air

P0091 Fuel Pressure Regulator 1 Control Circuit Low

How urgent? Get it checked in the next few days

What it means

On many diesel and direct-injection engines, the fuel pressure regulator is electronically controlled. The computer found a voltage that is too low in the circuit that operates it.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the regulator connector and wiring
  2. Measure the regulator resistance and compare to spec

Signs you may notice

  • Check engine light on
  • Hard starting, stalling or loss of power
  • Possible limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged wiring or loose connector to the regulator
  • CommonFailed fuel pressure regulator solenoid
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a wiring repair or a new fuel pressure regulator.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel pressure regulator. Prepare an itemized shop request.
Walk through it step by step: Engine stalls while driving →

Common questions

What does P0091 mean?

On many diesel and direct-injection engines, the fuel pressure regulator is electronically controlled. The computer found a voltage that is too low in the circuit that operates it.

Can I drive with code P0091?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0091?

Common possibilities to test include: damaged wiring or loose connector to the regulator; failed fuel pressure regulator solenoid; engine computer driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.