Home › Code lookup › P0701
Powertrain code · Transmission

P0701 Transmission Control System Range/Performance

How urgent? Get it checked in the next few days

What it means

The transmission computer sees that the transmission control system is not behaving the way it expects, even though no single circuit has failed outright.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other transmission codes and fix those first
  2. Check fluid level and condition
  3. Check for software updates for the transmission computer

Signs you may notice

  • Check engine or transmission light on
  • Rough or unusual shifting
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow or degraded transmission fluid
  • PossibleTransmission control module software or internal fault
  • PossiblePoor power or ground supply to the transmission computer

Typical repair once the cause is confirmed

Fix any related codes and fluid problems first; a computer reflash or replacement is needed only after power, ground and wiring check out.

Walk through it step by step: Transmission warning light on →

Common questions

What does P0701 mean?

The transmission computer sees that the transmission control system is not behaving the way it expects, even though no single circuit has failed outright.

Can I drive with code P0701?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0701?

Common possibilities to test include: low or degraded transmission fluid; transmission control module software or internal fault; poor power or ground supply to the transmission computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.