Home › Code lookup › P0705
Powertrain code · Transmission

P0705 Transmission Range Sensor A Circuit (PRNDL Input)

How urgent? Get it checked in the next few days

What it means

The computer isn't getting a good signal from the sensor that tells it which gear the shifter is in (Park, Reverse, Neutral, Drive).

Can I keep driving?

Use care. If the engine starts in Drive or Reverse, or the gear shown doesn't match the shifter, don't drive it until fixed, because the car could move unexpectedly or not hold Park. If it only affects shift quality or the dash display, drive gently to a shop soon and always set the parking brake.

What to test before replacing parts

Confirm the shifter position matches the range sensor reading in every gear on a scanner, and check sensor adjustment, the connector and the shift cable before replacing the sensor or computer.

  1. Check that the shifter lines up with the gear shown on the dash
  2. Inspect the range sensor connector for water, corrosion or damage
  3. Check the range sensor readings with a scanner while moving through each gear

Signs you may notice

  • Check engine light on
  • Engine may not start in Park or Neutral, or may start in gear
  • Gear indicator on the dash may be wrong or blank
  • Harsh or wrong shifting, or limp mode
  • Reverse lights may not work

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty transmission range sensor (neutral safety switch)
  • CommonRange sensor out of adjustment
  • CommonDamaged wiring or corroded connector at the sensor
  • PossibleWorn or misadjusted shift cable or linkage
  • PossibleFaulty transmission computer

Typical repair once the cause is confirmed

Usually adjusting or replacing the transmission range sensor, or repairing its wiring or the shift linkage.

Repair costInsufficient verified pricing for this vehicle and repair
Replace transmission range sensor. Prepare an itemized shop request.

Where it shows up

  • Often seen on older Ford trucks and SUVs, where the range sensor sits outside the transmission and is exposed to water and dirt

Known on these vehicles

Walk through it step by step: Car won't start →

Common questions

What does P0705 mean?

The computer isn't getting a good signal from the sensor that tells it which gear the shifter is in (Park, Reverse, Neutral, Drive).

Can I drive with code P0705?

Use care. If the engine starts in Drive or Reverse, or the gear shown doesn't match the shifter, don't drive it until fixed, because the car could move unexpectedly or not hold Park. If it only affects shift quality or the dash display, drive gently to a shop soon and always set the parking brake.

What causes P0705?

Common possibilities to test include: faulty transmission range sensor (neutral safety switch); range sensor out of adjustment; damaged wiring or corroded connector at the sensor; worn or misadjusted shift cable or linkage. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.