Home › Code lookup › P0702
Powertrain code · Transmission

P0702 Transmission Control System Electrical

How urgent? Get it checked in the next few days

What it means

The transmission computer has detected an electrical problem in the transmission control system, such as a bad power feed, ground or internal circuit.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check battery voltage and the fuses that feed the transmission computer
  2. Inspect transmission wiring and grounds for corrosion or damage

Signs you may notice

  • Check engine or transmission light on
  • Transmission stuck in one gear (limp mode)
  • Harsh or no shifting

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonPoor power or ground to the transmission computer
  • CommonDamaged wiring or corroded connector at the transmission
  • PossibleFailed transmission control module

Typical repair once the cause is confirmed

Repair the power, ground or wiring fault; replace and program the transmission computer only if it has failed internally.

Walk through it step by step: Transmission warning light on →

Common questions

What does P0702 mean?

The transmission computer has detected an electrical problem in the transmission control system, such as a bad power feed, ground or internal circuit.

Can I drive with code P0702?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0702?

Common possibilities to test include: poor power or ground to the transmission computer; damaged wiring or corroded connector at the transmission; failed transmission control module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.